Diagnostics
[ Diagnostics > LLDP > Configuration ]
292
RM GUI GRS
Release
8.0
09/2019
6.5.1 LLDP Configuration
[ Diagnostics > LLDP > Configuration ]
This dialog lets you configure the topology discovery for every port.
Operation
Operation
Enables/disables the
LLDP
function.
Possible values:
On
(default setting)
The
LLDP
function is enabled.
The topology discovery using LLDP is active in the device.
Off
The
LLDP
function is disabled.
Configuration
Transmit interval [s]
Specifies the interval in seconds at which the device transmits LLDP data packets.
Possible values:
5..32768
(default setting:
30
)
Transmit interval multiplier
Specifies the factor for determining the time-to-live value for the LLDP data packets.
Possible values:
2..10
(default setting:
4
)
The time-to-live value coded in the LLDP header results from multiplying this value with the value
in the
Transmit interval [s]
field.
Reinit delay [s]
Specifies the delay in seconds for the reinitialization of a port.
Possible values:
1..10
(default setting:
2
)
If in the
Operation
column the value
Off
is specified, then the device tries to reinitialize the port after
the time specified here has elapsed.
To Next Page
Loading...
