User interfaces
1.2
Command Line Interface
29
UM Config GRS
Release
8.0
09/2019
Parameters
The sequence of the parameters is relevant for the correct syntax of a command.
Parameters are required values, optional values, selections, or a combination of these things. The
representation indicates the type of the parameter.
The following list displays the possible parameter values within the Command Line Interface:
Table 4: Parameter and command syntax
<command>
Commands in pointed brackets (
<>
) are obligatory.
[command]
Commands in square brackets (
[]
) are optional.
<parameter>
Parameters in pointed brackets (
<>
) are obligatory.
[parameter]
Parameters in square brackets (
[]
) are optional.
...
An ellipsis (3 points in sequence without spaces) after an element
indicates that you can repeat the element.
[Choice1 | Choice2]
A vertical line enclosed in brackets indicates a selection option.
Select one value.
Elements separated by a vertical line and enclosed in square
brackets indicate an optional selection (Option1 or Option2 or no
selection).
{list}
Curved brackets (
{}
) indicate that a parameter is to be selected from
a list of options.
{Choice1 | Choice2}
Elements separated by a vertical line and enclosed in curved
brackets (
{}
) indicate an obligatory selection option (option1 or
option2).
[param1 {Choice1 |
Choice2}]
Displays an optional parameter that contains an obligatory selection.
<a.b.c.d>
Small letters are wild cards. You enter parameters with the notation
a.b.c.d with decimal points (for example IP addresses)
<cr>
You press the <Enter> key to create a line break (carriage return).
Table 5: Parameter values in the Command Line Interface
Value Description
IP address This parameter represents a valid IPv4 address. The address
consists of 4 decimal numbers with values from 0 to 255. The 4
decimal numbers are separated by a decimal point. The IP address
0.0.0.0
is a valid entry.
MAC address This parameter represents a valid MAC address. The address
consists of 6 hexadecimal numbers with values from 00 to FF. The
numbers are separated by a colon, for example,
00:F6:29:B2:81:40
.
string User-defined text with a length in the specified range, for example a
maximum of 32 characters.
character string Use double quotation marks to indicate a character string, for
example
“System name with space character”
.
number Whole integer in the specified range, for example
0..999999
.
date Date in format
YYYY-MM-DD
.
time Time in format
HH:MM:SS
.
To Next Page
Loading...
