Network load control
10.4
QoS/Priority
130
UM Config GRS
Release
8.0
09/2019
Configuring Layer 3 management priority
Perform the following steps:
network management priority dot1p 7
Assigning the VLAN priority of
7
to management
packets. The device sends management packets
with the highest priority.
show network parms
Displaying the priority of the VLAN in which the
device management is located.
IPv4 Network
------------
...
Management VLAN priority....................7
...
Open the
Switching > QoS/Priority > Global
dialog.
In the
IP DSCP value for management packets
field, specify the DSCP value with which the
device sends management data packets.
To save the changes temporarily, click the button.
enable
Change to the Privileged EXEC mode.
network management priority ip-dscp 56
Assigning the DSCP value of
56
to management
packets. The device sends management packets
with the highest priority.
show network parms
Displaying the priority of the VLAN in which the
device management is located.
IPv4 Network
------------
...
Management IP-DSCP value....................56
To Next Page
Loading...
