Hirschmann GREYHOUND GRS1020 - Page 517

Redundancy
12.5
Link Aggregation
177
UM Config GRS
Release
8.0 09/2019
Use the following steps to setup Switch 1 and 2 in the Graphical User Interface.
 Open the Switching > L2-Redundancy > Link Aggregation dialog.
 Click the button.
The dialog displays the Create window.
 In the Trunk port drop-down list, select the instance number of the link aggregation group.
 In the Port drop-down list, select the port 1/1 .
 Click the Ok button.
 Repeat the preceding steps and select the port 1/2 .
 Click the Ok button.
 To save the changes temporarily, click the button.
enable
Change to the Privileged EXEC mode.
configure
Change to the Configuration mode.
link-aggregation add lag/1
Creates a Link Aggregation Group lag/1 .
link-aggregation modify lag/1 addport
1/1
Adds port 1/1 to the Link Aggregation Group.
link-aggregation modify lag/1 addport
1/2
Adds port 1/2 to the Link Aggregation Group.