Entering the IP parameters
34
2.2
Entering the IP parameters via CLI
Basic - L3P
Release
3.1
06/07
D IP address of the gateway
This entry is only needed if the Switch and the management station/
tftp server are located in different subnetworks (see
“Example of how
the network mask is used” on page 30).
Enter the IP address of the gateway between the subnetwork with the
Switch and the path to the management station.
The default setting of the IP address is 0.0.0.0.
V Save the configuration entered with
copy system:running-config nvram:startup-config
and then press the Enter key.
Confirm that you want to save the configuration by pressing y.
After entering the IP parameters, you can easily configure the Switch via the
Web-based Interface (see Reference manual „Web-based Interface“).
NOTE: Enter '?' for Command Help. Command help displays all options
that are valid for the 'normal' and 'no' command forms. For
the syntax of a particular command form, please consult the
documentation.
(Hirschmann PowerMICE) >en
(Hirschmann PowerMICE) #network protocol none
(Hirschmann PowerMICE) #network parms 149.218.112.105 255.255.255.0
(Hirschmann PowerMICE) #copy system:running-config nvram:startup-config
Are you sure you want to save? (y/n) y
Copy OK: 15811 bytes copied
Configuration Saved!
(Hirschmann PowerMICE) #
To Next Page
Loading...
Need help?
General
