Protection from unauthorized access
Basic - L3P
Release
3.1
06/07
6.1
Password for SNMP access
77
V Select the Security:SNMPv1/v2 Access dialog. This dialog
gives you the option to select the access via SNMPv1 or SNMPv2. In
the state on delivery both protocols are enabled. Thus you can
manage the Switch via HiVision and communicate with earlier
versions of SNMP.
Please note that passwords are case-sensitive.
Select “SNMPv1/2c on” to be able to communicate with earlier versions
of SNMP.
If you select SNMPv1 or SNMPv2 in the table you can determine which
IP addresses are allowed to access the
Switch and which kind of pass-
words are to be used.
The table allows up to 8 entries.
For security reasons, the read password and the read/write password
must not be identical.
Please note that passwords are case-sensitive.
Index Current number for this table entry
Password Password, the computer has to use, to have access to the Switch. This
password is indepentent of the SNMPv3 password.
IP address IP address of the computer that is allowed to access the Switch.
IP mask IP mask to the IP address.
Access Mode Access Mode determines if the computer has read-only or read-write
access.
Active Enabling/Disabling this table entry.
To Next Page
Loading...
Need help?
General
