Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)09-03-60]
Rev.1.1
INST(IN)09-03-60
(3) Connect the LAN cables to the lower LAN ports on SSVP0 via the LAN cable kit.
(a) Connect the LAN cables between the LAN port (L0) on SSVP0 and the LAN board 1
(Management LAN port) on DKC-2. (When DKC-2 and DKC-3 are not installed, this step is
not necessary.)
(b) Connect the LAN cables between the LAN port (L1) on SSVP0 and the LAN board 1
(Management LAN port) on DKC-3. (When DKC-2 and DKC-3 are not installed, this step is
not necessary.)
(c) Connect the LAN cables between the LAN port (L2) on SSVP0 and the LAN board 1
(Management LAN port) on DKC-4. (When DKC-4 and DKC-5 are not installed, this step is
not necessary.)
(d) Connect the LAN cables between the LAN port (L3) on SSVP0 and the LAN board 1
(Management LAN port) on DKC-5. (When DKC-4 and DKC-5 are not installed, this step is
not necessary.)
When only DKC-0 and DKC-1 are installed, do not connect the connectors for the rear connection
on the LAN cable kit that is connected to the lower LAN ports on SSVP0 to anything.
(4) Connect the LAN cables to the lower LAN ports on SSVP1 via the LAN cable kit. (When SSVP1
is not installed, this step is not necessary.)
(a) Connect the LAN cables between the LAN port (L0) on SSVP1 and the LAN board 2
(Management LAN port) on DKC-2.
(b) Connect the LAN cables between the LAN port (L1) on SSVP1 and the LAN board 2
(Management LAN port) on DKC-3.
(c) Connect the LAN cables between the LAN port (L2) on SSVP1 and the LAN board 2
(Management LAN port) on DKC-4. (When DKC-4 and DKC-5 are not installed, this step is
not necessary.)
(d) Connect the LAN cables between the LAN port (L3) on SSVP1 and the LAN board 2
(Management LAN port) on DKC-5. (When DKC-4 and DKC-5 are not installed, this step is
not necessary.)
When only DKC-0 and DKC-1 are installed, do not connect the connectors for the rear connection
on the LAN cable kit that is connected to the lower LAN ports on SSVP1 to anything.
To Next Page
Loading...
