Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)15-01-30]
Rev.1
INST(IN)15-01-30
3. Conrmation procedure of HSTS setting
(1) Launching the Command Prompt as administrator
Select [Start]-[Windows System], right-click the displayed [Command Prompt], and then select
[More]-[Run as administrator].
(2) Changing the current directory
Run the following command in the Command Prompt.
“cd C:\DKC200\mp\pc”
(3) Checking that HSTS setting
Enter the following command in the Command Prompt:
“hstsState.bat”
• If “hsts = on” is displayed, HSTS is enabled.
• If “hsts = off” is displayed, HSTS is disabled.
• If “The system cannot nd the le specied.” is displayed, HSTS is not set.
(4) “Press any key to continue…” is displayed. Press the Enter key.
(5) Close the Command Prompt.
To Previous Page
