Hitachi DKC910I - Page 211

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)15-01-20]
Rev.1
INST(IN)15-01-20
2. Procedure for disabling HSTS
(1) Launching the Command Prompt as administrator
Select [Start]-[Windows System], right-click the displayed [Command Prompt], and then select
[More]-[Run as administrator].
(2) Changing the current directory
Run the following command in the Command Prompt.
“cd C:\DKC200\mp\pc”
(3) Disabling the HSTS setting
Run the following command in the Command Prompt.
“setHSTSDisable.bat”
(4) When “Press any key to continue...” is displayed in the Command Prompt, press the Enter key to
close the Command Prompt.
(5) Conrming that HSTS is disabled
(a) Launching the Command Prompt as administrator
Select [Start]-[Windows System], right-click the displayed [Command Prompt], and then select
[More]-[Run as administrator].
(b) Changing the current directory
Run the following command in the Command Prompt.
“cd C:\DKC200\mp\pc”
(c) Checking whether HSTS is disabled
Run the following command in the Command Prompt.
“hstsState.bat”
• If “hsts = off” is displayed, HSTS is disabled. Press the Enter key and close the Command
Prompt.
• If “hsts = on” is displayed, HSTS is not disabled. Press the Enter key and perform the
procedure from Step (3) again.
• If “The system cannot nd the le specied.” is displayed, you failed in making the HSTS
setting. Press the Enter key and perform the procedure from Step (3) again.