Hitachi DKC910I - Page 89

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(IN)07-04-20]
3. Installing Stoppers
Table 7-6 Stopper (for HSNBX) Components List (Per One Unit)
Item No. Parts name Parts No. Quantity Comment
1 Stopper (R) 3293037-2 1 Stopper (For HSNBX)
2 Stopper (L) 3293037-1 1 Stopper (For HSNBX)
3 Binding Screw (NI) SB516N 4 For xing the Stopper
(1) Remove the two binding screws and loop cable tie xing the rear sides of the rails.
Figure 7-14 Removing Binding Screws Fixing Rails
(2) Fix the stopper (L) and the loop cable tie with the two binding screws temporarily.
Tighten the binding screw in the lower hole on the stopper (L) to x the loop cable tie.
(3) Fix the stopper (R) and the loop cable tie with the two binding screws temporarily.
Tighten the binding screw in the lower hole on the stopper (R) to x the loop cable tie.
Figure 7-15 Installing Stoppers
Binding screws
Rear view of rack
Loop cable tie Loop cable tie
Stopper (L)
Rear view of rack
Stopper (R)
Binding screw Binding screw
Stopper (L) Stopper (R)
Loop cable tie Loop cable tie
Rev.2
INST(IN)07-04-20