BIOS CLEAR CMOS
4-1
7
After importing the BIOS settings, you must do sy
stem full reset (DC cycle) to
enable the new BIOS settings.
AMI Setup Control Environment (AMISCE) is a command line tool which provides
an easy way to update NVRAM variables, extract variables directly from the BIOS,
change settings using either a text editor or a setup program and update the BIOS.
AMISCE produces a script file that lists all setup questions on the system being
modified by AMISCE. The user can then modify the script file and use it as input to
change the current NVRAM setup variables. See ami.com for more information.
BIOS Revision
The BIOS revision is used to identify the BIOS image and BIOS phase.
Clear CMOS
The following steps will load the BIOS defaults by jumper:
1. Power down the syst
em.
2. Locate the switch SW3 on the mainboard.
3. Adjust the CMOS clear DIP from Off to On for a few seconds.
4. Move the CMOS clear DIP back to off.
5. Power on the system.
6. Check to see if the BIOS defaults are loaded.
SW1
SW1
BIT1: (Reserved)
BIT2: PASSWD CLEAR
Off (Open): Normal (Default)
On (Short): Password Clear
SW3
SW3
BIT1: CMOS CLEAR
Off (Open): Normal (Default)
On (Short): RTC Reset
BIT2: ME FW UPDATE
Off (Open): Normal (Default)
On (Short): ME Force Update
DIP Jumper Settings
To Next Page
Loading...
