Hitachi DS240 - SAS Mezzanine Card Assembly; Removing the SAS Mezzanine Card Assembly; Installing the SAS Mezzanine Card Assembly

INSTALLING THE HARDWARE SAS MEZZANINE CARD ASSEMBLY
2-21
2.7 SAS Mezzanine Card Assembly
For
further information about OCP Mezzanine Cards, see OCP Mezzanine Card on
page 2-26 .
Removing the SAS Mezzanine Card Assembly
1. Remove the mainboard sled. See Removing a Mainboard Sled on page 2-
11.
2. Remove the riser assembly. See Removing a PCIe Riser Assembly on page 2-14.
3. Locate the SAS mezzanine card assembly found in the back of the chassis.
4. Loosen the two captive screws securing the SAS mezzanine card assembly to the
chassis.
5. Lift up the SAS mezzanine card assembly to remove it from the chassis.
Figure 2-26. Removing the SAS Mezzanine Card Assembly
Installing the SAS Mezzanine Card Assembly
1. Remove the mainboard sled. See Removing a Mainboard Sled on page 2-
11.
2. Remove the riser assembly. See Removing a PCIe Riser Assembly on page 2-14.
Note:
You must first remove a PCIe expansion card assembly before replacing a
mezzanine card. See Removing a PCIe Riser Assembly on page 2-14.