Hitachi DS240 - Installing a SAS Mezzanine Card

INSTALLING THE HARDWARE INSTALLING A SAS MEZZANINE CARD
2-24
6. Replace the SAS mezzanine card.
Installing a SAS Mezzanine Card
1. Remove the mainboard sled. See Removing a Mainboard Sled on page 2-11.
2. Remove the riser assembly. See Removing a PCIe Riser Assembly on page 2-14.
3. Remove the SAS mezzanine card assembly. See Removing the SAS Mezzanine Card
Assembly on page 2-21.
4. Install the SAS mezzanine card to the riser card.
5. Fasten the five screws securing the SAS mezzanine card assembly to the SAS
mezzanine card bracket.
Figure 2-30. Install a SAS Mezzanine Card
6. Align the screw holes on the bracket over the corresponding screw holes on the
mezzanine card.
7. Lower the mezzanine card to install in place.
SAS Mezzanine Card
Riser Card
SAS Mezzanine Card
Bracket
❶
❷
❸
❸
❸
❸
❸