Hitachi DS240 - Loading BIOS Defaults

BIOS LOADING BIOS DEFAULTS
4-14
Loading BIOS Defaults
Different mechanisms exist for resetting the system configuration to the default values.
When a request to reset the system configuration is detected, the BIOS loads the default
system configuration values during the next POST. The request to reset the system to the
defaults can be sent in the following ways:
 A request to reset the system configuration can be generated by pressing <F9> from
within the BIOS Setup utility
 Load BIOS defaults by jumper as follows:
a. Power down the system.
b. Adjust CMOS clear DIP from Off to On for a few seconds.
SW1
SW3
SW1
SW1
BIT1: (Reserved)
BIT2: PASSWD CLEAR
Off (Open): Normal (Default)
On (Short): Password Clear
SW3
SW3
BIT1: CMOS CLEAR
Off (Open): Normal (Default)
On (Short): RTC Reset
BIT2: ME FW UPDATE
Off (Open): Normal (Default)
On (Short): ME Force Update
DIP Jumper Settings