Hitachi DS240 - Removing an Air Duct (General SKU)

INSTALLING THE HARDWARE REMOVING AN AIR DUCT (GENERAL SKU)
2-3
1
4. Press the latch plungers to secured position. Make sure the mid-brace and air duct
are locked in place.
Figure 2-37. Installing the Air Duct (GPU SKU)
5. Intall the mainboard sled. See Installing a Mainboard Sled on page 2-13.
Removing an Air Duct (General SKU)
1. Remove the mainboad sled. See Removing a Mainboard Sled on page 2-11.
2. Locate the air duct and grasp the air duct from the sides.
CAUTION!
ENSURE ALL POWER IS DISCONNECTED FROM THE SYSTEM BEFORE PROCEEDING.
Latch Plunger
Secured Open
Latch Plunger
Latch Plunger
Mid-Brace
!