Hitachi DS240 - Air Ducts; Removing an Air Duct (GPU SKU); Installing an Air Duct (GPU SKU)

INSTALLING THE HARDWARE AIR DUCTS
2-30
2.10 Air Ducts
Removing an Air Duct (GPU SKU)
1. Remove the mainboad sled. See Removing a Mainboard Sled on page 2-11.
2. Remove the PCIe riser assembly. See Removing a PCIe Riser Assembly on page 2-14.
3. Locate the air duct.
4. Release the latch plungers to the open position and grasp the air duct from the
sides.
5. Remove the air duct from the mainboard sled.
Figure 2-36. Removing the Air Duct (GPU SKU)
Installing an Air Duct (GPU SKU)
1. R
emove the mainboad sled. See Removing a Mainboard Sled on page 2-11.
2. Position the air duct in the mainboard sled, aligning it with the guide pins and guide
slots.
3. Carefully lower the air duct into the chassis.
CAUTION!
ENSURE ALL POWER IS DISCONNECTED FROM THE SYSTEM BEFORE PROCEEDING.
!
Latch Plunger
Secured Open
Latch Plunger
Latch Plunger
Mid-Brace