Hitachi DS240 - Power Supply Unit Installation

INSTALLING THE HARDWARE POWER SUPPLY UNIT
2-6
2.3 Power Supply Unit
Removing a Power Supply Unit
1. Lift the PSU handle up.
Figure 2-7. Opening the PSU Handle
2.
Press the release latch and pull the PSU out of the chassis.
Figure 2-8. Removing PSU
Installing a Power Supply Unit
1. Align the PSU in the chassis and make sure the release lever is positioned on the
right side.
CAUTION!
DISCONNECT THE POWER SUPPLY UNIT FROM THE POWER SOURCE BEFORE REMOVING PSU. FAILURE TO DO SO
COULD RESULT IN DAMAGE TO THE EQUIPMENT OR PERSONAL INJURY.
!