INSTALLING THE HARDWARE INSTALLING A PROCESSOR
2-37
8. Inspect all sides of the bracket to make sure the bracket is level with the carrier.
There should not be a gap between the bracket and the carrier. See the following
illustrations for further detail.
Figure 2-43. Validating Bracket Installation
The heat sink modules for processor 0/3 are different by design as compared to the
heat sink for processor 1/2. See the following guideline to identify the correct heat
sink to processor slot.
CPU 0/3
Figure 2-44. Heat Sink 0/3 Location
DO NOT HOLD THE HEAT SINK BY THE FINS. THE HEAT SINK FINS CAN BE EASILY BENT, WHICH RESULTS IN THE DIS-
RUPTION OF THE DESIGNED AIR FLOW PATTERN.
Correct
Installation
Incorrect
Installation
CPU0/3
Air
To Next Page
Loading...
