INSTALLING THE HARDWARE REMOVING A PROCESSOR
2-43
6. Turn the processor assembly over to expose the processor. Place the heat sink on a
clean work surface.
Figure 2-53. Processor Location on an Assembly
7. Locate the TIM release slot positioned on the opposite side of the PIN1 indicator.
Insert a flat blade screwdriver into the release slot marked on the processor bracket.
8. Twist the screwdriver to break the thermal paste seal. Make sure to twist and not pry
the screwdriver to prevent damage to the modules.
Figure 2-54. Separating Processor from the TIM on the Heat Sink
Make sure the tip of the screwdriver does not come in contact with the TIM substrate.
!
CPU
Release
!
CPU
R
elease
!
CPU
Release
Release Slot
PIN1
Indicator
To Next Page
Loading...
