● Install the product in an adequately ventilated location.
● Do not install the product in an enclosed space.
● Connect the product to exhaust equipment to prevent it from being filled with organic solvent
vapor.
● Secure adequate space for the ink/makeup handling area and product installation site. At least
200 m
3
must be provided per print head. Ensure that adequate ventilation is provided.
* If ink or makeup contains any organic solvents or specified chemical substances, it must be
managed under the Industrial Safety and Health Act.
● If extraneous noise enters the product, it may malfunction or break down.
For maximum noise immunity, observe the following installation and wiring precautions.
- Ensure that 100 or 200 VAC power cables are not bundled with other power supply cables.
- Insulate the product main body and print head so that they do not come into direct contact
with the conveyor or other devices.
- If the employed print target detector is housed in a metal case, use a plastic mounting brace
to insulate the detector from the conveyor and other devices.
- Ensure that the print target detector wiring is not bundled together with other power supply
cables.
To Next Page
Loading...
