Hitachi UX2 - Ready and Standby State Switching Operation

Chapter 4. Basic Operation
4-20
4.2.3. Ready and Standby State Switching Operation
This section describes operation of switching between ready state and standby state.
(1) [Ready] state → [Standby] state switching
● When the conveyor interlock is activated by the [Ready] output signal, if the status is changed to
[Standby], the conveyor will stop.
Press Ready at the top of the screen, and the [Print Abort Confirmation] message appears. Then, press
OK.
[Print Abort Confirmation] screen
1
Press Ready.
Press OK.