Hitachi UX2 - 4.3. Shutdown Operation

Chapter 4. Basic Operation
4-24
4.3. Shutdown Operation
This section describes the shutdown operation of the unit.
4.3.1. Automatically Stopping by Pressing STOP Switch Button
Press and hold the STOP switch for about two seconds.
All operations up to the unit power OFF are performed automatically.
Positions of operating status indicator lamps and each switch
● The power is turned OFF by the STOP switch when ink is being ejected or stopped.
(The main power switch does not have to be turned off. Power consumption does not
change even if the main power switch remains ON.)
Operating status indicator
lamps
Displays "Ready", "Fault" and
"Warning".
Main power switch
Turns
the unit ON and
OFF.
ON/STOP switch
Starts or stops the unit with
the main power on.