6.4. Updating Print Description at Fixed Interval (Time Count)
This section describes operation of updating the print description at a fixed interval.
(1) Time count function
● Updates the print description at predetermined update intervals (minutes).
● Define the base time once a day so that the print description is changed to the predetermined value when
the time comes.
● Only one time count value can be set in one message. Each value can contain up to three digits.
● Set time count conditions on the [Time count conditions] screen.
● Range, reset, reset time, and renewal period are available as conditions.
● The print description is always updated with an increment of 1.
● One time count condition is held for each message. To input the same time count condition to another
message, use the "copy" and "paste" functions. Input the time count condition, press Copy to copy, and
press Paste on the [Time count conditions] screen of another message.
● A time count value cannot be input to the count block of another count.
(Example) Range: AA to GG, renewal period: 30 minutes, reset time: 05:00, reset value: [AA]
Example of times and count values
To Next Page
Loading...
