Hitachi UX2 - Status

Chapter 4. Basic Operation
4-3
Chapter 4.
4.1.2. Status
The following table describes status types of the unit.
Status types
No.
Status
Description
1
Stop
The ink is stopped. No deflection voltage is applied.
2
Standby
The ink is ejected. No deflection voltage is applied.
3
Ready
The ink is ejected. The deflection voltage is applied (printing is permitted by
the sensor signal).
4
Starting
The unit is preparing for operation.
5
Ink heating
The unit is starting up with the ink being heated.
6
Stopping
The unit is performing the internal process to stop.
7
Drop adjust
The unit is in the standby state with ink particles not properly charged.
8
Cover open
The unit is in the standby state with the print head cover open.
9
Service
The unit is in the circulation control state for maintenance task execution.
10
Fault
A fault exists.
(1) The current status and the online/offline state are always displayed at the top of the screen.
Unit status sign (online/offline)
[Ready] state
[Stop] state
Online
Offline
ON