Hitachi UX2 - Setting Repeat Print

Chapter 5. Creation and Setting of Print Messages
5-34
5.6.2. Setting Repeat Print
This section describes settings of repeat print.
● Overview
– Set the repeat print when printing the same content successively.
– Set [Repeat intervals] and [Repeat count] when printing successively.
– When [Product speed matching] is set to [Auto], [Repeat print] cannot be set.
(a) [Repeat intervals]
● Sets the dimension of the print target.
● Use the setting when the print target is closely transported.
● Select the units of characters (CH) or length (mm) and then fine-adjust the value on an individual
scan basis (SC).
● To input in units of length (mm), need to specify [Speed].
● Calculate the [Repeat intervals] setting as follows:
(i) By scanning
(Character width of a digit x number of digits - end character correction value) x
(dimension of print target / print width of whole digits)
(ii) By character
Number of digits x (dimension of print target / print width of whole digits)
(Example)
Dimension of print target: 64 mm, Print width of whole digits: 25 mm,
Number of digits: 6, Dot matrix: 5 x 7 dots, Inter-character space: 2 dots
– By scanning
{(5＋2) x 1 x 6 - (2 x 1 + 1)} x (64 / 25) = 99.84→100
– By character
6 x (64 / 25) = 15.36→15
● Round off the decimal places of the calculation result.
● Character width of a digit
＝ (horizontal dot matrix ＋ inter-character space) x bold font value
● End character correction value ＝ inter-character space x bold font value + 1
Print target
Print target
Repeat intervals