Hitachi VM-E530A - Page 45

11. Point the remote control at the receiver on the
VCR and press the COPY START button to start
simple programmable edit.
• The camcorder automatically searches for
the beginning of the first segment and starts
playback. The recording VCR automatically
starts recording.
• After recording the first segment the cam¬
corder automatically searches for the begin¬
ning of the next segment and resumes play¬
back. The recording VCR is automatically
released from the record pause mode and
resumes recording.
• R continues recording and pausing until all
the programmed segments are edited.
12. When simple programmable edit is finished,
the camcorder will enter the stop mode, and the
VCR will enter the record pause mode.
■ Note: If you make a mistake during program¬
ming, start again from the beginning or press
the COUNTER RESET button to return to the pre¬
vious steps one by one and enter the correct
program data,
Note: After the simple programmable edit is
finished, the programmed data is erased, if
you want to continue editing other segments,
repeat steps 5- 12.
Note: Most VCRs (recording machine ) may
be released from the record pause mode if it
continues for more than five minutes.
Note: The dubbing start and end positions
may slightly drift from the specified positions
when certain VCRs are used.
Note: Reduce the volume of the camcorder
as low as possible during dubbing. Otherwise
the played back pictures could be distorted,
To End Programmable Simple Edit
Press the PROGRAM button to remove the pro¬
gram display from the viewfinder. Then press the
stop button on. the recording VCR to set it to the
stop mode.
Note: If the CAM/OFF/VIDEO switch of the
camcorder is set to OFF or CAM when the
recording VCR is in the record pause mode,
the VCR enters the record mode,
VM-E530A
E45