Hofmann MC10 HS - Measure Settings Submenu; System Settings Submenu; Statistics Submenu

MC10 HS Basic Operation - Main Menu
4 - 7
4.4.2 "Measure Settings" submenu
Rotor setup Create and change rotor and correction data, enter
units and tolerances
Data acquisition setup Display and set parameters for data acquisition
Calibration Display and set calibration parameters, perform cali-
bration
4.4.3 "System Settings" submenu
Access privileges Manage access privileges
System diagnostics Display system information
Setup MC10 Chose screen on-screen keyboard, confirm program
termination, remove USB device, quit MC10
4.4.4 "Statistics" submenu
Balance data Display, print, store saved measurement values as a
chart
Machine Performance Counters Display, print, save number of measured rotors