3-7
dummyheaddummyhead
MAINTENANCE
AIR CLEANER
REMOVAL/INSTALLATION (NC700X/
XA/XD)
Remove the center cover but do not disconnect the seat
lock cable and luggage box lid lock cable (page 2-16).
Remove the maintenance lid (page 21-6).
Disconnect the IAT sensor 2P (Black) connector [1].
Remove the air cleaner housing cover screws [2] and
air cleaner housing cover [3].
Release the air cleaner housing cover tabs [4] and
remove the air cleaner element [5] from the air cleaner
housing cover.
Inspect the air cleaner element in accordance with the
maintenance schedule (page 3-3) or any time it is
excessively dirt or damaged.
Install the air cleaner element in the reverse order of
removal.
Check that the condition of the packings [6], replace
them if necessary.
REMOVAL/INSTALLATION (NC700S/
SA/SD)
Remove the following:
– Side cowl (page 2-13)
– Maintenance lid (page 21-6)
Remove the air cleaner housing cover screws [1].
Remove the air cleaner housing cover [2] to the left side
and disconnect the IAT sensor 2P (Black) connector [3].
Release the air cleaner housing cover tabs [4] and
remove the air cleaner element [5] from the air cleaner
housing cover.
Inspect the air cleaner element in accordance with the
maintenance schedule (page 3-3) or any time it is
excessively dirt or damaged.
Install the air cleaner element in the reverse order of
removal.
Check that the condition of the packings [6], replace
them if necessary.
TORQUE:
Air cleaner housing cover screw:
1.1 N·m (0.1 kgf·m, 0.8 lbf·ft)
TORQUE:
Air cleaner housing cover screw:
1.1 N·m (0.1 kgf·m, 0.8 lbf·ft)
To Next Page
Loading...
Need help?
General
