Honda NC700 2012 User Manual

12-47
dummyheaddummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
4. Outer Mainshaft Sensor Input Line Open Circuit
Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
outer mainshaft sensor 3P (Black) connector [1] and
PCM 33P (Black) connector [2] terminals.
Is there continuity?
YES – GO TO STEP 5.
NO – Open circuit in the White/blue wire
5. Outer Mainshaft Sensor Ground Line Open
Circuit Inspection
Disconnect the PCM 33P (Gray) connector.
Check for continuity between the wire harness side
outer mainshaft sensor 3P (Black) connector [1] and
PCM 33P (Gray) connector [2] terminals.
Is there continuity?
YES – Replace the PCM with a known good one,
and recheck.
NO – Open circuit in the Green/yellow wire
6. Outer Mainshaft Sensor Output Line Open
Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
outer mainshaft sensor 3P (Black) connector [1] and
PCM 33P (Black) connector [2] terminals.
Is there continuity?
YES – GO TO STEP 7.
NO – Open circuit in the Pink/yellow wire
Connection: White/blue – A25
TOOL:
Test probe 07ZAJ-RDJA110
W/Bu
[1] [2]
A25
Connection: Green/yellow – B22
TOOL:
Test probe 07ZAJ-RDJA110
B22
[1]
G/Y
[2]
Connection: Pink/yellow – A21
TOOL:
Test probe 07ZAJ-RDJA110
A21
[2]
[1]
P/Y

Honda NC700 2012 Specifications

General

Engine Type	670cc liquid-cooled parallel-twin
Bore x Stroke	73.0mm x 80.0mm
Compression Ratio	10.7:1
Front Brake	Single 320mm disc with two-piston caliper
Rear Brake	Single 240mm disc with single-piston caliper
Fuel Capacity	3.7 gallons
Fuel System	PGM-FI
Transmission	6-speed
Front Suspension	41mm telescopic fork
Rear Suspension	Pro-Link single shock
Front Tire	120/70-17
Rear Tire	160/60-17
Wheelbase	60.6 inches
Curb Weight	472 pounds