Honda NC700 2012 User Manual

19-8
dummyheaddummyhead
HYDRAULIC BRAKE
BRAKE FLUID REPLACEMENT/AIR
BLEEDING (NC700X/S)
• Do not allow foreign material to enter the system
when filling the reservoir.
• When using a commercially available brake bleeder,
follow the manufacture’s operating instructions.
BRAKE FLUID DRAINING
Front brake: Turn the handlebar until the reservoir is parallel to the
ground.
Remove the reservoir cover screws [1], reservoir cover
[2], set plate [3] and diaphragm [4].
Rear brake: Support the motorcycle in an upright position.
Remove the rear brake reservoir mounting bolt [1] and
reservoir [2].
Remove the cover screws [3], reservoir cover [4], set
plate [5] and diaphragm [6].
Temporarily install the reservoir and mounting bolt to
the reservoir stay lower hole [7] using a 6 mm nut [8].
Align the reservoir tab [9] with the reservoir stay cut out
[10].
Connect a bleed hose [1] to the caliper bleed valve [2].
Loosen the bleed valve and pump the brake lever/pedal
until no more fluid flows out of the bleed valve.
Front:
[2]
[3]/[4]
[1]
[8]
[3]
[1][9][2][1][2]
[10]
[7]
Rear:
[6]
[5]
[4]
[2][1]
Front shown:

Honda NC700 2012 Specifications

General

Engine Type	670cc liquid-cooled parallel-twin
Bore x Stroke	73.0mm x 80.0mm
Compression Ratio	10.7:1
Front Brake	Single 320mm disc with two-piston caliper
Rear Brake	Single 240mm disc with single-piston caliper
Fuel Capacity	3.7 gallons
Fuel System	PGM-FI
Transmission	6-speed
Front Suspension	41mm telescopic fork
Rear Suspension	Pro-Link single shock
Front Tire	120/70-17
Rear Tire	160/60-17
Wheelbase	60.6 inches
Curb Weight	472 pounds