Galaxy Dimension Installer Manual
6-33
3 = Modify Name
This option allows a name to be assigned to the user (maximum 6 characters). Each of the user codes default
to the name USER. The engineer (ENG) and manager (MGR) are fixed and cannot be reprogrammed. On
selecting the Modify Name option, a section of the alpha-numeric characters that can be assigned to the user
name is displayed on the bottom line of the keypad; the cursor flashes on the letter L. Press the key to
erase the characters of the default or previous name. When the previous name has been erased, use the A or
B keys to move the cursor to the first character of the name and press the ent key; the selected character
appears on the top line. Continue this process until the name is completed.
The # key moves between upper and lower case characters and the system library. The alpha-numeric char-
acters and library words can be selected by entering the character or word reference number (refer to Appen-
dix A — Library) or by pressing the A or B keys.
When the user name is completed, press the esc key to accept the programming and return to the previous
menu level.
4 = Schedule
This option allows the user’s pin code access to the panel menu options for setting and unsetting. The pin code
only operates during the OFF period of an assigned weekly schedule which is created in option 65.1.
If a user attempts to use his pin code during the ON periods of his assigned schedule, then an illegal code
event is logged and any outputs programmed as illegal code are activated.
Setting this option to 00=None means that pin codes are always operational.
NOTE: This option does not control card access through doors at all. This is now controlled by templates
and is allocated to a user in option 42.11=Template.
42 - Codes (cont’d)
To Next Page
Loading...
Need help?
General
