EasyManuals Logo

Honeywell Galaxy Dimension series User Manual

Honeywell Galaxy Dimension series
306 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
Galaxy Dimension Installer Manual
5-7
MAX
3
The MAX
3
is a proximity reader access control device for a single door, which can also be used for setting
and unsetting of your alarm control panel. The MAX
3
can be configured in one of two ways:
Standalone
In this configuration the MAX
3
can be used for either door control or alarm system set/unset control, by either
connecting the internal relay output to a door lock or external relay. When in standalone mode the MAX
3
is
programmed and operated using the MAX
3
proximity cards or tags.The proximity cards and tags each have
unique ID numbers and must be identified to the MAX
3
before being used to operate the system. The MAX
3
memory can store up to 999 ID numbers, including at least three reserved for Masters. Once programmed,
the ID number of the tags and cards are stored indefinitely in the MAX
3
memory until voided (removed) or
erased. Removing power from the MAX
3
does not erase the programming memory.
Note : The MAX
3
defaults to standalone mode. It can be configured to on-line mode directly from the
Galaxy Dimension control panels.
On-line
The MAX
3
can operate in on-line mode, with the Galaxy Dimension control panel range, as a completely
integrated module on the system. In this configuration the MAX
3
can be used for both door control and alarm
system set/unset control with complete user traceability stored within the Galaxy control panel.
For detailed instructions on how to programme the MAX
3
onto the system in on-line mode refer to Option
69.2=MAX.
Installing the MAX
3
MAX
3
Pack
Your Max
3
pack contains the following:
• Max
3
proximity reader *
• Max
3
drilling template
• Max
3
installation instructions
• Surge suppressor
* The MAX
3
is supplied with 3 metres of 12 wire E111235 AWG cable which is fixed and sealed through a
keyhole opening on the rear surface of the MAX
3
.
Mounting the MAX
3
To mount the MAX
3
use the step by step diagrams provided with the drilling template.
The drilling template should be used as an aid to locate the holes required to secure the MAX
3
and insert the
connection cable.
The MAX
3
comes with an infra red lid tamper. The tamper is activated when the lid is removed from the
MAX
3
unit.
Access Control (cont’d)

Table of Contents

Other manuals for Honeywell Galaxy Dimension series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Galaxy Dimension series and is the answer not in the manual?

Honeywell Galaxy Dimension series Specifications

General IconGeneral
ModelGalaxy Dimension series
UsersUp to 250
PartitionsUp to 8
Operating Temperature-10°C to +55°C
CompatibilityHoneywell Galaxy accessories and peripherals

Related product manuals