EasyManuals Logo

Honeywell Galaxy Dimension series User Manual

Honeywell Galaxy Dimension series
306 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #266 background imageLoading...
Page #266 background image
Galaxy Dimension Installer Manual
6-192
71 - SPI Key
Engineer 3
Option 71 – SPI Key
The SPI (Serial Peripheral Interface) key is an engineering peripheral used for copy/overwriting programming
data and carrying out software upgrades.
Using the SPI Key
If no key is fitted the display will briefly show:
SPI Keys can be supplied in one of two ways:
1. Programmed - the SPI Key will be pre-programmed with a specific application file.
2. Un-programmed - The SPI Key is blank and contains no application or configuration data.
If the SPI Key is fitted and the key is blank, then the only option presented to the user will be 1 = Format
Key.
1 = Format Key
This function formats the key ready for copy and overwriting of panel configuration data. On selecting this
option the user is presented with a display where the top line reads “Formatting”, with a progress bar shown
on the bottom line.
Once the key has been formatted the user is presented with the following options:
1 = Show Key
This option is only shown when there is existing information stored on the SPI Key and then provides options
for downloading the saved information into the panel. The user can scroll through the available files on the SPI
Key.
For each file the display toggles between the:
Filename, creation time and date of the saved data and the,
Panel Type, Panel version and file type.
A further press of the ent key will provide the user with the following two options:
1 = Use File
Selecting this option will reprogram your control panel with the software application file or configuration file
stored on the SPI key. This will take approximately 2 minutes.
NOTE: If a new panel application file is being downloaded, the panel configuration stored in the
panel should firstly be saved from the panel to the SPI Key. The new panel application can
then copied from the SPI Key to the panel. Once the new application has been
downloaded the saved panel configuration can be copied back to the panel.
SPI Key:SPI Key:
SPI Key:SPI Key:
SPI Key:
Device errorDevice error
Device errorDevice error
Device error

Table of Contents

Other manuals for Honeywell Galaxy Dimension series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Galaxy Dimension series and is the answer not in the manual?

Honeywell Galaxy Dimension series Specifications

General IconGeneral
ModelGalaxy Dimension series
UsersUp to 250
PartitionsUp to 8
Operating Temperature-10°C to +55°C
CompatibilityHoneywell Galaxy accessories and peripherals

Related product manuals