Honeywell Galaxy Dimension series User Manual

Galaxy Dimension Installer Manual
2-16
Outputs
The Galaxy Dimension control panel on-board outputs are detailed in the following table:
Table 2-9. Outputs
Figure 2-14. Terminator and Keyswitch Zone Wiring
Wiring Terminator Buttons
Zones programmed as Push-Set (terminator) buttons can be open going closed (2 kΩ to 1 kΩ) or closed
going open (1 kΩ to 2 kΩ). The first activation of the terminator button initialises its status to the system.
NOTE: The first activation of a terminator may not set the system as this can be the initialisation routine. If
the system continues setting, push the button again. The system will set on the second push. This
initialisation only occurs on the first setting. All subsequent setting routines set on the first push of the
terminator.
The wiring of the terminator and keyswitch zone type is shown in the following figure:
Terminator Zone Wiring
sserddAtuptuO
tluafeD
noitcnuF
epyTgnitaR
etatSlamroN
)pu-llup3k3htiw(
tluafeDelbanE0eniL
10011001slleBdesirotsis
narTAm004,V21evitisoP
20012001ebortSeloPelgniS
revOegnahC
)OCPS(yaleR
A1,V03desigrene-eD
30013001APdesirotsisnarTAm0
04,V21evitisoP
40014001teseRdesirotsisnarTAm004,V21evitisoP
11011100teSdesirotsisnarTAm004,V21evitisoP
21012100redurt
nIdesirotsisnarTAm004,V21evitisoP
31013100mrifnoCdesirotsisnarTAm004,V21evitisoP
41014100teseRdesirotsisnarTAm004,V
21evitisoP
Keyswitch
zone
Push-set
zone
1k to unset, 2k to set
1k
1%
Open - Closed
1k
1k
1k
1k
500m
OR
Closed - Open
1%
1%
1%
1%

Honeywell Galaxy Dimension series Specifications

General

Model	Galaxy Dimension series
Users	Up to 250
Partitions	Up to 8
Operating Temperature	-10°C to +55°C
Compatibility	Honeywell Galaxy accessories and peripherals