Honeywell Galaxy Dimension series User Manual

Galaxy Dimension Installer Manual
6-68
65 = Reset levels
This parameter determines the type of user that can reset specific fault types. The default values are shown in
the table below.
Table 6-12. User Type Reset Level
51 - Parameters (cont’d)
2=Tamper
This parameter determines the number of invalid code attempts, which can be tried before system tamper
occurs. Lockout tamper can be programmed between 0 and 21. Default is 15. Setting to 0 disables the
function.
63 = Banner Alerts
This parameter determines whether system alerts are displayed on the Galaxy keypad banner. If enabled
system events will be indicated on the display. The default value for this parameter is disabled.
64 = Set Override
This parameter determines the type of user that can override specific fault events to set the system. The default
values are shown in the table below.
Table 6-11. User Type Override Level
A different value can be programmed for each group.
epyTtluaF
epyTresU
leveLedirrevO
metsyS1.2
repmaT6.3
AP1.2
liaFeniL6.3
tluaFlareneG1.2
liafrewoP1.2
NOTE: This parameter affects and is affected by parameters 51.6 (System Reset), 51.7 (Tamper Reset) and
51.22 (PA Reset). If the parameter reset level is changed at 51.65 then this change is reflected at
51.6, 51.7 and 51.22.
66 = Min Pin Size
This parameter determines the minimum size of each user code. This can be set from four to six digits. The
default is five digits.
Fault Type
User Type
Reset Level
System 3.6
Tamper 3.7
PA 3.6
Line Fail 3.7
General Fault 3.7
Power Fail 3.6

Honeywell Galaxy Dimension series Specifications

General

Model	Galaxy Dimension series
Users	Up to 250
Partitions	Up to 8
Operating Temperature	-10°C to +55°C
Compatibility	Honeywell Galaxy accessories and peripherals