Honeywell Galaxy Dimension series User Manual

Galaxy Dimension Installer Manual
6-127
56 - Communications (cont’d)
56.3.02 Secondary
The secondary option is available to support Dual and Alternate dialling to a second destination receiver. If
using alternate mode both the dial type and format must be identical to the values programmed for the primary
number.
1 = Default Telephone Number
The programming is identical to Telephone Number 1.
2 = Default Account Number
Refer to Primary format
3 = Dial Type
Refer to Primary Dial Type (except X.25 should be option not available).
4 = Format
Refer to Primary Format. It is possible to assign different formats to both the Primary and Secondary num-
bers, however, when using the alternative signalling option the format must be identical.
5 = Copy Primary (1 to 2)
Copies Primary Program to Secondary Program, for ease of programming.
6 = Alternate
If enabled, signalling is attempted alternately to primary and secondary numbers until successful transmission to
either is achieved. If enabled, the user will be requested to copy the primary programming to the secondary
programming to ensure both paths are configured identically.
56.3.03 ISDN Type
Two types of ISDN lines are available on the EURO ISDN network; Point to Multipoint and Point to Point.
This option allows selection of the type to be used.
1 = Point to Multipoint (default)
This configuration is used when more than one ISDN system is connected to the ISDN bus. To ensure that the
ISDN module responds to incoming calls from Remote Servicing only a specific MSN (Multiple Subscriber
Number) should be entered. The MSN number should be provided by the Telecom provider.
NOTE: All devices not programmed with an MSN number will also respond to incoming calls.

Honeywell Galaxy Dimension series Specifications

General

Model	Galaxy Dimension series
Users	Up to 250
Partitions	Up to 8
Operating Temperature	-10°C to +55°C
Compatibility	Honeywell Galaxy accessories and peripherals