INTELLIDOX DOCKING MODULE USER MANUAL || ASSEMBLE MODULES
HONEYWELL PAGE 21 OF 119
Removing Connected Modules from Mounted Back Panels
1. Disconnect the power cord, network cable, tubing and inlet filter assemblies.
2. Unlock and lift the latch arm between the two modules at the end of the group.
3. Find the panel latch at the top right side of the module at the end of the group.
4. Press down firmly on the panel latch, and then continue to press down while you push the
module to the right until the hinge pins and hooks are detached. For best results,
Honeywell recommends that you hold the remainder of the group firmly in position while
pushing to help protect the remaining modules in the group from excessive movement or
falls.
5. Repeat steps 2, 3 and 4 until only one module remains.
6. Repeat steps 3 and 4 to remove the final module.
To Next Page
Loading...
Need help?
General
