Honeywell IntelliDoX User Manual

INTELLIDOX DOCKING MODULE USER MANUAL || HIBERNATION
HONEYWELL PAGE 74 OF 119
Configure Hibernation
You must use Safety Suite Device Configurator or Safety Suite software to create a
configuration file to activate hibernation on insertion. After the configuration file is created,
you can use Safety Suite Device Configurator or Safety Suite software, or a USB flash
drive to transfer the file to one or more modules. When a module is configured to activate
hibernation on insertion, the LCD changes to gray and the hibernation symbol is
displayed. All other module functions are disabled.
Detectors in hibernation mode do not respond to gas. Do not use detectors in
hibernation mode as personal protective equipment (PPE).
Work Plan: Configuring Hibernation
1. Create a hibernation configuration file.
2. Transfer the hibernation configuration file to one or more modules via Safety Suite
Device Configurator or Safety Suite software, or USB flash drive.
3. Activate detector hibernation.

Honeywell IntelliDoX Specifications

General

Data Logging	Yes
Calibration	Automatic
Bump Testing	Automatic
Instrument Management	Yes
Input Voltage	100-240 VAC, 50/60 Hz
Enclosure Rating	IP20
Connectivity	Ethernet, USB
Operating Temperature	0°C to 40°C (32°F to 104°F)
Humidity Range	10% to 90% (non-condensing)
Communication Protocol	Modbus TCP/IP