INTELLIDOX DOCKING MODULE USER MANUAL || PREPARE MODULES FOR USE
HONEYWELL PAGE 30 OF 119
Connect the Power
Each IntelliDoX Enabler Kit contains one power supply and AC power cord. Use only the
power supply provided in the Enabler Kit to connect the module to an appropriate electrical
power outlet. When the power is connected, the module activates and a self-test is performed.
Connecting the Power
1. Verify that the power supply and power cord provided in the Enabler Kit are compatible
with the local power source. If the power supply is not compatible, do not attempt to
connect the module to a power source. Contact Honeywell or an authorized distributor
immediately.
2. Connect the AC power cord to the power supply.
3. Connect the power supply into the power connection on the module. Press firmly until you
hear a click. The click confirms that the plug is locked.
4. Plug the AC power cord into a suitable wall outlet.
5. When the power is connected, the LCD activates and a self-test is performed.
Disconnecting the Power
To deactivate a module or group of modules, disconnect the power supply. The module or
group of modules deactivates immediately and without warning.
1. Retract the plastic cover on the plug to unlock it.
2. While the cover is retracted, pull the plug out of the module.
To prevent the corruption or loss of data and/or software and/or firmware, do not
deactivate the equipment while performing datalog transfers, bump tests, calibrations or
other operations.
To Next Page
Loading...
Need help?
General
