Honeywell IntelliDoX User Manual

INTELLIDOX DOCKING MODULE USER MANUAL || CONFIGURE SETTINGS VIA
SAFETY SUITE DEVICE CONFIGURATOR AND SAFETY SUITE SOFTWARE
HONEYWELL PAGE 66 OF 119
Configure Module and Detector Settings via Safety Suite Device
Configurator
Certain features, options and settings for the module and/or compatible detectors can be
configured through Safety Suite Device Configurator software. You must use Safety Suite
Device Configurator software to create a configuration file that is compatible with the
module. After the configuration file is created, transfer it to one or more modules to
implement the new configuration settings. For more information, refer to the Safety Suite
Device Configurator operator manual and the appropriate detector operator manual.
Workflow: Configuring Settings
1. Create the configuration file.
2. Transfer the configuration file to one or more modules via Safety Suite Device
Configurator software or via USB flash drive.
3. Transfer configuration settings to a detector.

Honeywell IntelliDoX Specifications

General

Data Logging	Yes
Calibration	Automatic
Bump Testing	Automatic
Instrument Management	Yes
Input Voltage	100-240 VAC, 50/60 Hz
Enclosure Rating	IP20
Connectivity	Ethernet, USB
Operating Temperature	0°C to 40°C (32°F to 104°F)
Humidity Range	10% to 90% (non-condensing)
Communication Protocol	Modbus TCP/IP