INTELLIDOX DOCKING MODULE USER MANUAL || CONFIGURE SETTINGS VIA
SAFETY SUITE DEVICE CONFIGURATOR AND SAFETY SUITE SOFTWARE
HONEYWELL PAGE 62 OF 119
Protect Module Operations with a Passcode
You can configure a passcode to control access to certain module operations. When an
operation is protected by a password, a lock symbol is displayed with the menu icon.
Protected operations that are not performed automatically on insert may be performed
only after the correct passcode is entered on the module. You must use Safety Suite
Device Configurator software to configure and manage the passcode.
Configuring a Module Passcode via Safety Suite Device Configurator
Software
1. Start Safety Suite Device Configurator software, and then log in as an administrator.
2. Select Configure Devices via IntelliDoX on the Devices menu. The IntelliDoX
Configuration Selection dialog box is displayed.
3. Select a configuration file and click OK. The IntelliDoX Device Configuration dialog
box is displayed.
4. Select the tab for a compatible detector, and then select the IntelliDoX
Configuration tab for the compatible detector.
5. In the IntelliDoX Operations section, select the operations you want to protect with a
passcode.
6. In the IntelliDoX Passcode section, click or to select a 4-digit number.
7. Click Save to IntelliDoX to transfer the passcode configuration settings to one or
more modules. For more information, see Transferring the Configuration File to a
Module via Safety Suite Device Configurator.
To Next Page
Loading...
Need help?
General
