Honeywell IntelliDoX User Manual

INTELLIDOX DOCKING MODULE USER MANUAL || UPDATE FIRMWARE
HONEYWELL PAGE 86 OF 119
Updating Module Firmware via Safety Suite Device Configurator
When a module or group of modules is connected to a network, you may transfer the
firmware update file to multiple selected modules via Safety Suite Device
Configurator software. The update is processed only when the module or group of
modules is idle. You can verify the version of the installed firmware as well as other
module details via the IntelliDoXs on the Administration menu in Safety Suite Device
Configurator.
For more information, refer to the Safety Suite Device Configurator operator manual.
1. Download and save the firmware update file to a PC or network drive. Do not rename
the file.
2. Start Safety Suite Device Configurator software, and then log in as an administrator.
3. Select Configure Devices via IntelliDoX on the Devices menu. The IntelliDoX
Configuration Selection dialog box is displayed.

Honeywell IntelliDoX Specifications

General

Data Logging	Yes
Calibration	Automatic
Bump Testing	Automatic
Instrument Management	Yes
Input Voltage	100-240 VAC, 50/60 Hz
Enclosure Rating	IP20
Connectivity	Ethernet, USB
Operating Temperature	0°C to 40°C (32°F to 104°F)
Humidity Range	10% to 90% (non-condensing)
Communication Protocol	Modbus TCP/IP