Honeywell SmartLine ST 700 - Page 183

Revision 12 ST 700 SmartLine Pressure Transmitters User’s Manual Page 167
Calibrate Low
Correct
[31LO COR]
Two-point Field
Accuracy Calibration
Method for DP/AP/GP
transmitters
Not normally used. See Field
Calibration for Alternate
Ranges, below.
Executing this selection
corrects input pressure to be at
or near the Cal Low Point
without compromising LRV and
URV corrections. A trial-and-
error approach using different
Cal Adjust Ratio values and
repeated executions of Cal
Low Correct followed by Cal
High Correct may be required.
The live value of the primary
pressure input is shown on this
display so the user can easily
see the result of the correction.
Note: Cal Low Correct must be
performed before Cal High
Correct, but Cal High Correct
may be repeated as
necessary.
Press  to
enter menu
selection
Press  to
initiate action
Calibrate High
Correct
[32 HI COR]
Two-Point Field
Accuracy Calibration
Method for DP/AP/GP
transmitters
Not normally used. See Field
Calibration for Alternate
Ranges, below.
Executing this selection
corrects input pressure to be at
or near the Cal High Point
without compromising LRV and
URV corrections. A trial-and-
error approach using different
Cal Adjust Ratio values and
repeated executions of Cal
Low Correct followed by Cal
High Correct may be required.
The live value of the primary
pressure input is shown on this
display so the user can easily
see the result of the correction.
Note: Cal Low Correct must be
performed before Cal High
Correct, but Cal High Correct
may be repeated as
necessary.
Press  to
enter menu
selection
Press  to
initiate action
Screen Rotation
[33 SCRROT]
OFF
ON
Automatic display screens
switch function.:
Select ‘ON’ or ‘OFF’ to rotate
display screens automatically.
Press  to
enter menu
selection
Menu to
select from
list
 to enter