Honeywell SmartLine ST 700 - Page 196

Page 180 ST 700 SmartLine Pressure Transmitters User’s Manual Revision 13
6ШклЦАП
[6SPANTR]
Note: Loop must be
removed from
Automatic Control
DAC Span Trim
This selection allows the
loop span output 20mA
value to be trimmed.
Note: You must connect a
current meter to the
transmitter to monitor the
loop output.
the next digit
to the right
7ТокТст
[7 LPTEST]
Note: Loop must be
removed from
Automatic Control
Loop Test
12.000
This selection allows the
user to force the DAC output
to any value between 3.8
and 20.8 mA.
Note: This selection will put
the DAC into Fixed Output
Mode, as indicated by the
flashing output value.
Navigation away from this
menu item will return the
loop to Normal (Automatic)
Mode.
Press  to
enter menu
selection
 to select
number.
 to enter
and shift to
the next digit
to the right
8УстLRV
[ 8SETLRV]
Set LRV
Executing this selection
performing for Zero
operation.
Note: The PV value shown
in bottom line will be
available in Pressure Units
(Simple Display pressure
unit)
Press  to
enter menu
selection
Press  to
initiate action
9УстURV
[ 9SETURV]
Set URV
Executing this selection for
Span operation
Note: The PV value shown
in bottom line will be
available in Pressure Units
(Simple Display pressure
unit)
10Кнтрст
[ 10CNTRST]
Contrast level
Adjust the LCD contrast
level.
Range from » (1) to
»»»»»»»»» (7)
Default: »»»»»»» (7)
Press  to
enter Menu
selection
Menu to
select level.
 to Enter
11КорLRV
[11LRVCOR]
Calibration Methods
perform an input calibration
correction by applying
process input at the
configured LRV level.
Press  to
enter menu
selection
Press  to
initiate action
12КорURV
[12URVCOR]
Calibration Methods
perform an input calibration
correction by applying
process input at the
configured URV level.
Press  to
enter menu
selection
Press  to
initiate action