Avalanche Update using File > Settings
Use these menu options to setup the Avalanche Enabler on the Thor VM1. Change the settings and save them by rebooting
before connecting to the network.
Alternatively, the Mobile Device Server can be disabled until needed (refer to the Wavelink Avalanche Mobility Center
User’s Guide for details).
Menu Options
Note: Your Thor VM1 screen display may not be exactly as shown in the following menu options. Contact
your representative for version information and upgrade availability.
Connection
Enter the IP Address or host name of the Mobile Device Server. Set the order in which serial ports or
RF connections are used to check for the presence of the Mobile Device Server.
Server Contact Setup synchronization, scheduled Mobile Device Server contact, suspend and reboot settings.
Data Control when data is transferred between the device and the Mobile Device Server.
Preferences Set options for Enabler startup or shutdown and logging.
Display
Set up the Windows display at startup, on connect and during normal mode. The settings can be
adjusted by the user.
Taskbar Set options for Taskbar.
Execution Not available in this release. Use AppLock instead, which is resident on each device.
Scan Config
This option allows the user to configure Enabler settings using a special bar code that is created by
the Avalanche MC Console. Scan Config not currently supported.
Shortcuts Add, delete and update shortcuts to user-allowable applications.
SaaS Configure the Enabler to connect with Avalanche on Demand.
Adapters
Enable or disable network and wireless settings. Select an adapter and switch between the Ava-
lanche Network Profile and manual settings.
Status
View the current adapter signal strength and quality, IP address, MAC address, SSID, BSSID and
Link speed. The user cannot edit this information.
5-9
To Next Page
Loading...
Need help?
General
