Honeywell Thor VM1 Reference Guide

WPA PSK
To connect using WPA/PSK, make sure the following profile options are used:
l Enter the SSID of the Access Point assigned to this profile
l Set EAP Type to None
l Set Encryption to WPA PSK or WPA2 PSK
l Set Auth Type to Open
Click the WEP keys/PSKs button.
This value can be 64 hex characters or an 8 to 63 byte ASCII value. Enter the key and click OK.
Once configured, click the Commit button.
Ensure the correct Active Profile is selected on the Main tab and warmboot. The SCU Main tab shows the device is associated
after the radio connects to the network.
6-37

Honeywell Thor VM1 Specifications

General

Brand	Honeywell
Model	Thor VM1
Category	Automobile Accessories
Language	English