Honeywell Thor VM1 Reference Guide

Disconnect UPS Battery
Equipment Required- User Supplied:
l Torquing tool capable of measuring inch pounds
l #2 Philips screwdriver bit
Caution
The UPS battery must be disconnected before shipping the Thor VM1, replacing the UPS battery or replacing the
front panel.
1. For convenience, the Thor VM1 can be removed from the Quick Mount Vehicle Dock, though it is not necessary.
2. Place the Thor VM1 in Suspend.
3. Place the Thor VM1 face down on a stable surface.
4. Using a #2 Philips bit loosen the M3 screws and then remove the tethered access panel with the SIM label. This panel is
on the right hand side when the Thor VM1 is face down with the top away from the user.
5. Locate the small push button located just below the SIM card installation slot.
6. Press the push button to disconnect the UPS. The UPS battery maintains its charge but is disconnected from the power
circuitry of the Thor VM1.
7. Reattach the access panel, torquing the M3 screws to 4-5 inch pounds using a #2 Philips bit.
8. When the Thor VM1 is attached to external power, the UPS battery is automatically reconnected.
2-36

Honeywell Thor VM1 Specifications

General

Brand	Honeywell
Model	Thor VM1
Category	Automobile Accessories
Language	English