Honeywell Thor VM1 Reference Guide

6. For EAP-TLS, also enter the User Cert (User Certificate filename) on the credentials screen by using the Browse
button.
7. Click the OK button then the Commit button.
8. When the device attempts to connect to the network, a sign-on screen is displayed.
9. Enter the Username and Password. Click the OK button.
10. Verify the device is authenticated by reviewing the Status tab. When the device is property configured, the Status Tab
indicates the device is Authenticated and the method used.
11. The sign-on screen is displayed after a reboot.
Note: See Configuring the Profile for more details.
If a user enters invalid credentials and clicks OK, the device associates but does not authenticate. The user is again prompted
to enter credentials.
If the user clicks the Cancel button, the device does not associate. The user is not prompted again for credentials until:
l the device is rebooted,
l the radio is disabled then enabled,
l the Reconnect button on the Diags Tab is clicked or
l the profile is modified and the Commit button is clicked.
6-20

Honeywell Thor VM1 Specifications

General

Brand	Honeywell
Model	Thor VM1
Category	Automobile Accessories
Language	English