HP 54710A - Page 4

Accessories Supplied
The following accessories are supplied with the oscilloscope.
•
This User’s Reference
•
One Programmer’s Reference
•
One Service Guide
•
One 2.3 meter (7.5 feet) power cord
See Also
The Service Guide for available power cords.
Accessories Available
The following accessories are available for use with the oscilloscope.
CAUTION
Make sure you use the correct length screw to rackmount the oscilloscope.
If you use a screw that is too short, it may not hold the oscilloscope safely in
the rack. If you use a screw that is too long, it can damage the oscilloscope.
•
HP 54710-68703 (Opt 907) Rackmount kit, handles only. Includes
M4 X 0.7 X 12 mm flat-head screws, HP part number 0515-2227
•
HP 54710-68704 (Opt 908) Rackmount kit, ears only. Includes M4
X 0.7 X 14 mm flat-head screws, HP part number 0515-0435
•
HP 54710-68705 (Opt 909) Rackmount kit with ears and handles.
Includes M4 X 0.7 X 20 mm flat-head screws, HP part number
0515-0456
•
HP 54720-68701 (Opt 002) Training kit including a PC board,
training guide, and power supply
•
HP 10087A HP 54710A to HP 54720A upgrade service
•
HP 54701A 2.5-GHz active probe
•
HP 54006A 6-GHz passive probe
•
HP 10430A 500-MHz 6.5-pF passive probe
•
HP 10441A 500-MHz 9-pF passive probe
•
HP 1141A 200-MHz differential probe
•
HP 1142A Power supply for HP 1141A Probe
iii