Statistics
Statistics calculates the mean and standard deviation and the minimum and
maximum of the automatic measurement results. The statistics results are
displayed below the lower right portion of the graticule area. This is the
same area where the marker results are displayed. If the marker results are
displayed instead of the statistics results, either turn off the manual and
waveform markers or turn off the readout for the measurement markers.
When you turn statistics on, the mean, standard deviation, minimum, and
maximum values start to accumulate at the same time. All results are
continuously updated, even though only one pair of results is currently
displayed. For example, if you select minimum and maximum, the minimum
and maximum values are displayed on the screen and they are updated as the
results change. The mean and standard deviation results are also calculated
and continuously updated, even though they are not displayed on the screen.
As the statistics accumulate, you can switch between displaying the
minimum and maximum values, or the mean and standard deviation values.
Define Measure Menu
Statistics
7–9
To Next Page
Loading...
